Passenger safety
Passenger safety briefings and risk assessments for RIB rides and boat trips: a checklist for UK operators
A passenger safety briefing for a boat trip or RIB ride should explain lifejackets, how to sit and hold on, what to do in an emergency, how to signal if someone feels uncomfortable, and who should not take part, such as people who are pregnant or have back or neck problems on high-speed rides. Pair each risk with the action passengers should take: when to wear a lifejacket and how to fit it, how to sit and hold on, and how to signal discomfort. The briefing must match a risk assessment based on how the trip is actually run, including sea state, speed, seating and the mix of passengers. MAIB investigations into RIB passenger injuries often find that briefings, seating and speed in waves did not match the real conditions.
This guide includes a briefing checklist, a way to check passenger suitability, advice on seating, and tips for writing a risk assessment that fits the actual trip.
"Risk assessments need to reflect actual operations"
This was one of six lessons for workboat operators highlighted by Maritime Journal in October 2026, based on recent MAIB findings. One example is the sea safari RIB Lundy Explorer.
In June 2023, near Ilfracombe, a passenger in a front jockey seat was thrown out when the RIB hit a wave. She suffered a spinal fracture and was left permanently paralysed. The MAIB's report (11/2025) found:
- The weather deteriorated quickly.
- The front jockey seats were unsuitable for single occupancy.
- The briefing covered lifejackets and emergencies, but not posture or handholds.
- "The use of jockey seats was not risk assessed."
- The boat was certified under the Small Commercial Vessel Code (MGN 280), which did not include requirements for seating.
The MAIB recommended that the operator put in place a safety management system covering pre-departure checks, briefings, accurate risk assessments and jockey seat use. It also recommended that the MCA assess vertical impacts and require the forthcoming Sport or Pleasure Vessel Code to cover the risks of seating people in the front third of a boat.
Why RIB passengers get hurt
Collisions and capsizes often make the news, but a common cause of serious RIB passenger injuries is less obvious: spinal injuries from the boat slamming down after going over a wave.
- Vertical impacts happen when a fast boat drops off a wave. Passengers keep moving down even after the hull stops, sending the shock up their spines.
- The bow takes the biggest hits. The industry's voluntary code notes that bow seats take higher shock loads. The MAIB's 2023 safety bulletin warned of a much higher risk of spinal fracture in forward seats "at any speed".
- Posture and grip matter. If a passenger sits upright with straight legs and loose hands, they take the full shock. Bending the knees, leaning forward and holding on firmly help reduce the impact, so explain these in the briefing.
- Conditions can change quickly. A sea that appeared fine at the start of the trip can be very different an hour later, especially if the wind is against the tide.
MCA guidance on whole body vibration, MGN 436 Amendment 4, covers how operators should assess and manage shocks and vibration on fast craft.
The passenger safety briefing checklist
The RYA, Passenger Boat Association and British Marine's voluntary code of practice for high-speed craft and experience rides sets out what a briefing should cover. Adapted for any trip boat or RIB:
- Welcome and who's in charge. The skipper and crew, and that passengers must follow their instructions.
- Lifejackets. How to put one on, adjust it, fit the crotch straps, and when to wear it. Check every passenger's fit, including children's.
- How to sit. Back against the seat or jockey seat, knees bent, feet flat, weight slightly forward. Not standing, not perching.
- Where to hold on. Show the handholds for each seat. Use both hands with a firm grip at all times when moving.
- What the trip will be like. The planned route, likely sea state, and when it might get bumpy.
- How to signal. A simple hand signal for "slow down" or "I'm not comfortable", and make clear that the skipper will respond when a passenger uses it.
- Emergencies. What happens if someone goes overboard, if the boat has a problem, or if you have to abandon. Where the liferaft or lifebuoys are.
- Health check. Ask, privately if needed, whether anyone has back or neck problems, is pregnant, or has other conditions that rule out a high-speed ride, and use the answers to decide who should not take part.
- Consent. Confirm each passenger understands and is willing to go.
Give the safety briefing before every trip, either on shore or while the boat is still alongside, and use clear, simple language. Repeat the main points (sit, hold and signal) just before you start moving at speed.
For vessels under the Workboat Code Edition 3, the briefing is a requirement. Before any voyage, the master must brief everyone on board, as a minimum, on the stowage and use of lifejackets, thermal protective aids and lifebuoys, and on emergency procedures. The master must also brief at least one other person on the liferaft and how to launch it, recovering a person from the sea, pyrotechnics, the radios, light switches and firefighting equipment.
Who should not ride, and where to seat people
Screening. The voluntary code recommends that operators do not allow higher-risk passengers on high-speed trips, such as people who are pregnant or have back problems. Many operators also include neck problems, recent surgery and heart conditions, and set a minimum age or height. Ask about these at booking and again during the briefing, and make it easy and private for people to opt out.
For slower trip boats, the list is shorter, but mobility, seasickness and the needs of young children still matter for seating and boarding.
Seating. The Workboat Code (section 25.4) sets clear rules for high-speed or planing operations. The operator must risk-assess all such operations and provide individual inboard seating for everyone that lets them brace and gives lateral support, positioned so people avoid the greatest shock loads. Everyone stays seated (or stood over a jockey seat) unless moving for a specific purpose, and on a RIB or open boat people sit only in designated inboard seats, never on the tubes or gunwale. The vessel must also meet the Control of Vibration at Work Regulations 2007 and MGN 436. In practice, match the seating to the conditions and the passengers:
- Avoid seating passengers in the front third, especially in waves, because that is where the biggest shock loads occur. The Lundy Explorer passenger was in a front jockey seat, and the MAIB recommended that seating in the front third of the boat be addressed in the coming code.
- Match seats to passengers. Seat anyone more vulnerable, such as older or smaller passengers or those with back trouble who still want a gentle trip, closer to the stern.
- Assess jockey seats before use. The MAIB found Lundy Explorer's front jockey seats were unsuitable for single occupancy, and their use hadn't been risk-assessed.
- Handholds for every seat. Every passenger needs something solid to hold that they can reach without losing their posture.
- Do not overload the boat. It is better to have fewer passengers in the safest seats than to fill every seat in rough conditions.
A risk assessment that reflects the trip you actually run
The Seadogz investigation found that some risk assessments were "cursory and generic". A general "RIB ride" assessment that could apply to any boat is not helpful and will not hold up if reviewed. Write a separate assessment for each trip type and route, covering:
- Route. Exposed sections, tide races, overfalls, traffic, the slowest safe route home.
- Conditions. Wind, swell and wind-against-tide limits for the trip, and the limits for each seating position.
- Speed. Speeds for each sea state, and the rule that the skipper slows down in waves regardless of the schedule.
- Seating. Which seats are used in which conditions, jockey seat use, handholds.
- Passengers. Screening questions, children, mobility, language, the maximum number in each condition.
- Briefing. What is covered, who gives it and how it is recorded.
- Emergency. Man overboard, injury on board (including a suspected spinal injury), breakdown, the nearest landing points.
- Crew. Who is qualified for this trip and what happens if crew numbers drop.
Go/no-go and in-trip decisions. Write down your limits and check them before every trip, using both the forecast and what you see on the day. During the trip, the skipper should slow down, change the route or turn back if conditions go beyond the plan, and record the decision each time. Under the Workboat Code Edition 3, operators must assess risks for both the operation and everyone on board, including vulnerable people.
Review your risk assessment at least once a year, after any injury or near miss, and whenever you change the boat, seating or route.
A real example
High-speed RIB rides always carry a risk of injury. That is why, on trips with the companies I work with, we always give a safety briefing before leaving. Even so, there have been times when we had to drop passengers off during the trip because they felt uncomfortable.
Fortunately, I work with responsible companies that have already risk-assessed their trips, so skippers aren't forced to make tough decisions on their own.
Lessons from MAIB investigations
- Lundy Explorer (sea safari RIB, report 11/2025): a passenger in a front jockey seat suffered a spinal fracture and permanent paralysis. Deteriorating weather, front jockey seats unsuitable for single occupancy, a briefing without posture or handholds, and jockey seat use not risk-assessed.
- Safety bulletin 3/2023, issued after the same accident: much higher risk of spinal fracture in forward seats at any speed. Operators urged to review operations and risk assessments and to align briefings with the voluntary code and MGN 436.
- Seadogz (high-speed passenger RIB, report 10/2023): the RIB hit a navigation buoy at 38.4 knots in Southampton Water; a 15-year-old passenger died. No safety management system, risk assessments that were "cursory and generic", and seats and handholds that gave little protection.
- Anguilla day-excursion boat (2023, reported by Maritime Journal): an 11m excursion boat was overwhelmed by ground seas in a cove; the mate and a passenger died. An ineffective safety management system, an unassessed operation and no passage plan.
The main issue is the gap between the planned trip and what actually happens on the water. The seating, speed and route used on the day were often never properly assessed.
Quick checklist
- A risk assessment per trip type and route, with written weather, speed and seating limits
- A briefing script covering lifejackets, posture, handholds, signals, emergencies and consent
- Screening questions at booking and at the briefing
- Passengers kept out of the front third in waves, and jockey seat use assessed
- Every seat has a handhold within reach
- A go/no-go check before every trip, recorded
- The briefing, passenger count and any declined passengers recorded for each trip
- Injuries and near misses reported, and the risk assessment reviewed after each one
How Helmsman helps
- Risk assessment doesn't reflect the trip as run. Risk assessments linked to each trip type and route, with review dates and a prompt to review after any incident.
- Briefing not given consistently, or not evidenced. Charter and ticketed trip records with a pre-departure checklist that logs the briefing, the passenger count and suitability declarations, with a timestamp.
- Conditions exceed the limits the trip was planned for. Plan Voyage records the planned route, forecast and operating limits before departure, so the go/no-go decision is logged against the risk assessment.
- Passenger injuries and near misses not followed up. Incident reporting mapped to MAIB and RIDDOR reporting needs, with corrective actions such as seating changes or a revised briefing tracked to close-out.
Helmsman links each trip's briefing, passenger count and go/no-go decision to the risk assessment, so your records show the actions taken on the trip you actually ran.
FAQs
What should a passenger safety briefing on a boat trip include?
Who is in charge, how to fit and wear a lifejacket, how to sit and where to hold on, what the trip will be like, how to signal discomfort, what happens in an emergency, a health check and confirmation that each passenger is willing to go.
Do RIB ride operators need a risk assessment?
Yes. Employers must risk-assess their work activities, and the MAIB has repeatedly found generic or missing risk assessments in RIB accidents. It should cover the route, conditions, speed, seating, passengers, briefing and emergencies for the trip as actually run.
Why do passengers get spinal injuries on RIB rides?
When a fast boat drops off a wave, the hull stops and the passenger keeps moving down, sending the shock up the spine. Forward seats take the biggest loads, and poor posture or a loose grip make it worse.
What seating is safest for passengers on a high-speed RIB?
Individual inboard seats towards the stern, with a firm handhold for every passenger. The Workboat Code requires individual inboard seating located so people avoid the greatest shock loads, and on a RIB nobody sits on the tubes. The MAIB has warned of a much higher risk of spinal fracture in forward seats, and found front jockey seats on one RIB unsuitable for single occupancy.
Who should be advised not to go on a high-speed boat ride?
The voluntary code says to screen out higher-risk groups, including people who are pregnant or have back conditions. Many operators also exclude people with neck problems or recent surgery.
Do passengers have to wear lifejackets on a RIB?
The Workboat Code requires a suitable lifejacket for every person on board, including children, and a briefing on how to use them before every voyage. The voluntary code treats wearing them at all times afloat as good practice. Set a clear wearing rule in your risk assessment.
Sources
- Maritime Journal: MAIB report reveals six safety lessons for workboat operators (5 October 2026)
- MAIB report 11/2025: Serious injury to a passenger on the sea safari RIB Lundy Explorer
- MAIB safety bulletin 3/2023: Safety warning following a serious passenger injury during a RIB ride
- MAIB report 10/2023: Seadogz
- RYA, PBA and British Marine: Passenger safety on small commercial high-speed craft and experience rides, a voluntary code of practice
- MGN 436 (M+F) Amendment 4: Whole body vibration
- The Workboat Code Edition 3
Helmsman runs this six-stage process for you — capture to close-out, with the records joined up so they survive an audit.
Join the waitlistAbout this guide. Written by John Wilmans, a working skipper who has been through a domestic safety management audit from the side of the operator being audited.Reviewed by John Wilmans on 13 October 2026.
This guide is general information, not legal advice, and it describes United Kingdom (MCA), small commercial vessels, high-speed passenger RIBs and trip boats. Requirements differ between flag states and administrations — always confirm with your own flag state or administration. This guide is general information, not legal or medical advice. Spotted something wrong?Tell me and I'll correct it.