Crew safety
Man overboard on small workboats: prevention, recovery and drills
A man overboard plan for a small workboat has three key steps: stop anyone from falling in, find them fast if they do, and get them back on deck within minutes. The last step is often the hardest. On small crews, the person who falls in usually knows the recovery kit best, while the person left on board may never have lifted a heavy, waterlogged adult out of the water.
This guide covers what the rules require, how to prevent man overboard incidents, how recovery works in cold water, and how to run drills that focus on actually getting someone back on board, not just raising the alarm.
Why MOB on a workboat is different
There is not much time. The MAIB looked at 20 man overboard accidents and found crews had, on average, less than 11 minutes to get someone out of cold water. Sometimes they had only four or five minutes. Out of 308 MOB incidents between 2015 and 2023, about 40% were fatal (MAIB, July 2023).
On a small workboat, several things make those minutes harder:
- Two or three crew. Losing one person right away leaves the boat short-handed. On a two-person crew, the person left on board has to steer, call for help, watch the person in the water and recover them, all by themselves.
- Freeboard. A deck that is easy to step off at the quay is much higher above the water when you have to pull a heavy, waterlogged adult back on board.
- Overside work. Mooring, towing, buoy work, crew transfers and line handling all put people close to the edge, often at night and sometimes in rough conditions.
- Cold UK water. The RNLI considers anything below 15°C to be cold water, and UK sea temperatures are below that for most of the year (RNLI).
What the rules expect
Most UK workboats up to 24m now sit under the Workboat Code Edition 3, brought into force by the Merchant Shipping (Small Workboats and Pilot Boats) Regulations 2023 (SI 2023/1216) from 13 December 2023. The sections that matter for MOB are:
- Section 14.4, lifejackets. A suitable lifejacket for every person on board, plus two spares if they are inflatable. Each has a whistle and retro-reflective material, and a light on vessels in area categories 0, 1, 2, 3 and 5. Inflatables are serviced within a month either side of the compliance, renewal and intermediate examinations, and at least annually in between.
- Section 14.7, recovery of persons from the water. An efficient means of recovering a person, conscious or unconscious, must be physically demonstrated to the Certifying Authority at each compliance and renewal examination.
- Section 14.8, training manual. Kept at a control position and covering, among other things, donning lifejackets and recovering people from the water.
- Section 14.11, drills, training and recording. Fire and abandon-ship drills carried out regularly and routinely. Recovery-of-persons drills carried out regularly and recorded, with MOB drills run in daylight, low light and a range of weather, logged and reviewed by the Certifying Authority. All crew familiarised with lifesaving appliances and emergency procedures.
- Section 28.2, single-handed operations. Not recommended. Where allowed, the master wears a lifejacket at all times and a PLB with GPS and a light on the open deck at sea, and no overside work takes place.
The MCA's guidance on recovery equipment is MGN 544 Amendment 1, updated in April 2026 after the MAIB's Humber Saturn investigation. The main point is that you need a plan, a procedure and equipment that can recover a person who cannot help themselves. Recovery should be horizontal whenever possible.
The Code of Safe Working Practices (COSWP) adds the working-practice layer. Its safety induction chapter expects every new crew member to know what to do if a person falls overboard and where the lifejackets are. Its emergency drills chapter covers how drills are run.
Underneath all of this sits the general duty to risk-assess work activities under the Merchant Shipping and Fishing Vessels (Health and Safety at Work) Regulations 1997 (reg 7). If people work near the edge, you are expected to have assessed MOB as a risk.
Prevention: keeping people on board
The best man overboard incident is the one that never happens. Most prevention steps are simple, but people often skip them when the weather is good.
- Lifejackets on deck, worn properly. Set a simple rule: anyone on an open deck while under way wears one. Fit crotch straps. In the MAIB's Copious investigation, a lifejacket worn incorrectly did not keep the casualty's airway clear (MAIB report 3/2023).
- Service and check lifejackets regularly. Under the Workboat Code, inflatable lifejackets are serviced within a month either side of each compliance, renewal and intermediate examination, and at least annually in between. Keep a record of who has each jacket and when it was last inspected.
- Lights and PLBs. A lifejacket light or AIS/PLB beacon turns a night search into a recovery.
- Clip on where needed. Use jackstays and short tethers for foredeck work in rough seas. If a tether is too long, you could still go over the side and be dragged.
- Reduce the risk at the edge. Make sure bulwarks and guardrails are the right height, use slip-resistant surfaces at mooring and transfer points, and keep gates closed unless they are in use.
- No lone working on deck. If someone has to go forward or overside, the wheelhouse must know, and someone must be able to see them.
- Risk-assess the job, not just the boat. Transfers to fish-farm barges, buoys, other vessels and pontoons are where people go over. In the Beinn Na Caillich case, the transfer had not been risk-assessed.
Recovery: the part most plans skip
Most written man overboard procedures explain the first two minutes well but are unclear about the last five. Here is a practical recovery sequence for a small workboat:
- Shout and point. "Man overboard, starboard side." One person keeps eyes on the casualty and points, and does nothing else.
- Mark the position. As soon as the shout goes out, press MOB on the plotter and throw a lifebuoy with a light or danbuoy.
- Raise the alarm right away. Send a MAYDAY on VHF DSC and by voice. Do not wait to see if you can manage it alone.
- Return to the casualty. Use the manoeuvre you have practised for this boat. Approach so the casualty is on the side you recover from, with the propeller well clear.
- Make contact and secure them. Attach a line, throw bag or boathook to the lifejacket harness. Once they are attached to the boat, you have time.
- Lift them out horizontally. Use the recovery equipment on board, such as a sling, parbuckle net, davit or recovery platform. MGN 544 is clear: "recovery in a vertical position should be avoided whenever possible as it risks cardiac arrest in hypothermic casualties."
- Treat for cold and shock. Keep them flat, sheltered and monitored, and get medical advice even if they say they are fine.
Can your crew recover an unconscious person? That is the real test. In the Humber Saturn case, the pilot boat's recovery platform could not be raised, and the casualty was left partly in cold water for over 40 minutes. If your plan only works when the person can climb a ladder, you are not ready for the worst case.
Cold water shock. In the first minute, people often gasp and panic. The RNLI recommends that anyone in the water resists the urge to swim and floats on their back until their breathing calms down. For the crew, this means the person in the water might not be able to grab a line right away, so throw them a buoyant line and keep talking to them.
Drills that actually test recovery
If a drill ends when the lifebuoy hits the water, it only tests the alarm, not the recovery. MGN 544 says recovery drills can be combined with man overboard drills, and they should end with the person back on deck.
What a useful MOB drill on a small workboat looks like:
- Use a realistic dummy. A weighted, waterlogged, adult-sized dummy. Practising with a fender on a rope doesn't teach you how to lift 90kg out of the water or how to recover an unconscious person.
- Practise with your actual crew, including the scenario where the skipper falls in and the deckhand must bring the boat back alone.
- Time it from the initial shout to the dummy back on deck. Compare your results to the MAIB's 11-minute average and see where you lose time.
- Practise the unconscious casualty. Rig and use the recovery sling, net or platform every time, not just on paper.
- Rotate roles. Everyone helms, everyone spots, everyone rigs the recovery gear.
- Debrief and record. Note what went wrong and what you will change, then check it has changed at the next drill.
- Practise in real conditions. Start with a calm drill alongside, then move on to drills at sea, in a breeze, and at least once in the dark.
The Workboat Code (section 14.11) requires recovery drills to be carried out regularly and recorded, and MOB drills to be run in daylight, low light such as dusk, and a range of weather conditions, noted in the Official Log Book and reviewed by your Certifying Authority. Your recovery equipment also has to be physically demonstrated at each compliance and renewal examination, so practise with it well before the surveyor arrives. Many operators drill monthly and whenever crew change, and new crew should take part in a MOB drill before they work on deck.
Lessons from MAIB investigations
The same lessons appear in many cases. MAIB investigations concentrate on learning, not blame, and the points below come from the published reports.
- Finnhawk / Humber Saturn (report 2/2026): a pilot fell from a pilot ladder into the water. The pilot boat's recovery platform was defective and could not be raised. The MAIB recommended that non-SOLAS vessels carry an alternative means of recovering an unconscious person.
- Copious (report 3/2023): a crew member went overboard. The lifejacket was worn incorrectly and did not keep the airway clear, and there was no training or equipment to recover an unconscious person.
- Reul A Chuain (report 14/2022): two people went overboard. Neither wore a PFD and the crew had not done MOB drills. The skipper entered the water to help and died.
- Beinn Na Caillich (report 6/2021): a crew member was crushed during a transfer to a feed barge and fell into the water. No regular MOB drills, crew unfamiliar with the recovery equipment, and no risk assessment for the transfer.
Three of these cases involve fishing vessels or pilot boats, not workboats. The lessons still apply: wear your lifejacket correctly, practise using the recovery gear, and plan for a casualty who cannot help themselves.
Quick checklist
- MOB is in the risk assessment for every overside and transfer job
- Lifejacket rule for open decks is written down and followed
- Every lifejacket is fitted with crotch straps, light and in-date servicing
- The boat carries a means of recovering an unconscious person horizontally
- Every crew member has used the recovery gear in a drill
- MOB drills are timed, include the two-handed scenario and are recorded
- New crew do a MOB drill before working on deck
- Near misses (slips, trips at the rail, lost tethers) are reported and acted on
How Helmsman helps
Helmsman cannot pull someone out of the water, but it helps you keep your plan up to date between drills:
- Drills skipped or never recorded. Drill schedules per vessel, with reminders when a MOB drill is due and a record of who took part, how long recovery took and what to change.
- New crew working on deck before a MOB drill. Crew inductions and competency tracking flag anyone who hasn't completed a MOB drill or recovery-gear familiarisation on that vessel.
- Lifejackets and recovery gear out of service. Lifesaving equipment records with service dates and inspection checklists, so expired or missing kit is flagged.
- MOB not in the risk assessment for a job. Risk assessments and method statements linked to each task, with review dates.
- Near misses at the rail never reported. Incident and near-miss reporting from a phone, with corrective actions tracked to close-out.
Helmsman keeps your man overboard plan, drills, equipment and crew records organised, so you can show both an auditor and yourself that the plan is actually being practised.
FAQs
How long do you have to recover someone from cold water?
Not long. The MAIB's analysis of 20 accidents found crews had, on average, under 11 minutes, and sometimes only four or five. Plan and practise for that window.
Do workboat crew have to wear lifejackets?
The Workboat Code requires a suitable lifejacket for every person on board, and on single-handed operations the master must wear one at all times. For crewed vessels, your risk assessment should set when they are worn. A simple, defensible rule is that anyone on an open deck while under way wears one, properly fitted with crotch straps.
What is the best way to lift a person out of the water?
Horizontally, or in a "deck-chair" position. MCA guidance in MGN 544 says vertical recovery should be avoided where possible because it risks cardiac arrest in hypothermic casualties.
How often should a workboat do man overboard drills?
The Workboat Code says regularly and routinely, recorded in the Official Log Book, and run in daylight, low light and a range of weather. It doesn't set a fixed interval. Many operators drill monthly and whenever crew change. What matters most is that every crew member has used the recovery gear.
What should a MOB drill include?
The alarm, marking the position, a MAYDAY call, returning to the casualty, attaching them to the boat and a full recovery to the deck using a realistic dummy, followed by a debrief and a written record.
What if the skipper goes overboard?
Plan for it. On a two-handed boat, the deckhand must be able to stop or turn the boat, make a MAYDAY call and recover the skipper. Include this scenario in your drills.
Sources
- MAIB: Planning and preparation vital to reduce man overboard fatalities (July 2023)
- The Workboat Code Edition 3
- The Merchant Shipping (Small Workboats and Pilot Boats) Regulations 2023
- MGN 544 Amendment 1, Annex 1: means of recovery of persons from the water
- Code of Safe Working Practices for Merchant Seafarers, 2026 edition
- Merchant Shipping and Fishing Vessels (Health and Safety at Work) Regulations 1997, reg 7
- RNLI: Cold water shock
- MAIB reports linked in the lessons section above
Helmsman runs this six-stage process for you — capture to close-out, with the records joined up so they survive an audit.
Join the waitlistAbout this guide. Written by John Wilmans, a working skipper who has been through a domestic safety management audit from the side of the operator being audited.Reviewed by John Wilmans on 13 October 2026.
This guide is general information, not legal advice, and it describes United Kingdom (MCA) — Workboat Code Edition 3, small commercial vessels. Requirements differ between flag states and administrations — always confirm with your own flag state or administration. Spotted something wrong?Tell me and I'll correct it.